Rising Damp and Salt Damp in Melbourne Period Homes

Damp walls are one of the most common findings in Melbourne's older homes. Many Victorian and Edwardian houses were built with damp proof courses that have since failed, been bridged, or were never there to begin with.

Rising damp

Rising damp is ground moisture drawn up into masonry walls. A damp proof course (DPC) is a barrier near the base of the wall that is meant to stop it. In older homes the DPC may be slate, bitumen or lead, and over a century it can crack, break down or be bypassed.

Common signs include:

  • Bubbling, flaking or powdery paint on the lower part of internal walls
  • A tide mark roughly up to a metre above the floor
  • Crumbling mortar or eroded brick faces outside
  • A musty smell in the room

Salt damp

Salt damp is the damage left behind when that moisture evaporates. Salts carried up in the water crystallise in the plaster and brick and slowly break them down. That is why a wall can keep deteriorating even after the moisture source has been reduced.

What bridges a damp course

We often see damp that isn't the DPC's fault at all. Garden beds built up against walls, concrete paths poured above the DPC line, rendered plinths and blocked subfloor vents can all let moisture straight past it. These are usually cheaper to fix than a full damp treatment.

How we check

We look at the wall faces inside and out, check ground levels against the DPC where it is visible, and use a moisture meter on suspect areas. A meter reading alone doesn't tell the whole story, so we read it alongside what we see.

Is it a deal breaker?

Usually not, but it does affect your budget. Repairs can range from lowering a garden bed to injected chemical damp courses and replastering with a salt-resistant render. If damp is found in your inspection, we will explain the likely cause and the type of contractor to talk to for a quote.

Next
Next

What a Building and Pest Inspection Covers in Victoria